STL Files

Click Click Boom Mount 20mm STL

$15.00

3D Printed mounting system for the Gilbert Engineering Click Click Boom 47″. The mounts provide a frame structure behind the coro to increase strength and allow mounting to various surfaces as well as provide rigidity to the prop after it has been slit in half for shipping. The mounts are sized to fit 20mm conduit and are then zip tied to the coro. To add additional strength to the system, the conduit is designed to be secured to the mounts and the prop by utilizing an 80mm long M6 screw / bolt with a corresponding nut at each mount post location. The center junction is made using a 25mm PVC cross which allows the smaller conduit to pass through utilizing the included bushings file.

For those in the UK, the links below are where you can get the conduit and PVC fittings.

Link to Conduit

Link to PVC Cross

Note: This is a digital purchase for STL files and not a physical product.

Category: STL Files Tag: Metric Conduit STLs

Description
Reviews (0)

As stated above, the conduit is secured to the mounts and the prop by utilizing a 80mm long M6 screw or bolt at each mounting post location. This is done to add additional strength to the mounts as well as to make a stronger connection to the prop itself. You will have to make a 6mm hole in the prop at each location to be able to insert the screw or bolt. It does not matter whether the screw or bolt is inserted from the front or back side, but in either case it is recommended to use a washer on the front side to spread the force over more of the coro. When tightening the nut, only tighten until snug. Be careful not to overtighten or you could crack the mounts.

General instructions for attaching mounts to coro props, including zip tie hole alignment, can be found by clicking this link.

Please follow and like us: