Because of the high weight of the prop the mounts for the Warlock are both zip tied and bolted to the coro. At each of the 8 post mounts you will need a 75mm long M6 bolt, (2x) M6 nuts and a M6″ washer in addition to zip ties. Start by embedding the M6 nut into the bottom of all the mounts. The easiest way to insert them is to temporarily insert the bolt from the top of the mount and thread the nut onto the bolt. As you tighten the bolt it will pull the nut into the mount. You can then mark on the prop where to make the holes for both the zip ties and for the M6 post mount bolt to go through the coro. While the prop may look symmetrical, the hole patterns at the outer mounts vary by a couple of millimeters. The mounts were designed using the average hole locations and thus holes on the prop will not be perfectly centered with the holes on the mounts. There is plenty of extra clearance, so just center the mount amongst all the holes. After the holes are made on the coro you can zip tie the mounts to the prop. Insert the conduit into the mounts and mark where the holes need to be drilled for inserting the bolts through the mounts. If your prop was slit in half for shipping, it’s always best practice to run the continuous piece of conduit perpendicular to the slit. Next drill 6mm holes completely through the conduit at all the hole locations. Glue the bushings into the PVC cross using epoxy or super glue and then feed the conduit into the mounts with the completed PVC cross in the center. At each post you will insert the bolt from the top of the mount and tighten it against the embedded nut at the bottom of the mount. Just careful not to over-tighten or you could crack the mount. The excess length of the bolt should now be sticking out of the front of the prop where you will insert the washer and another M6 nut and tighten that down until it fits snug.
Reviews
There are no reviews yet.