Small World Mount 20mm STL

$15.00

3D Printed mounting system for the Gilbert Engineering Small World 46″. The mounts provide a frame structure behind the coro to increase strength and allow mounting to various surfaces as well as provide rigidity to the prop after it has been slit in half for shipping. The mounts are sized to fit 20mm conduit and are designed to be zip tied to the coro. The conduit slides through the mounts with the center junction utilizing a 25mm PVC cross which allows the smaller conduit to pass through with the included bushing file. The conduit is then secured to the mounts using screws to lock the mounting frame in place to the prop. More information below.

For those in the UK, the links below are where you can get the conduit and PVC fittings.

Link to Conduit

Link to PVC Cross

Note: This is a digital purchase for STL files and not a physical product.

Many of the the pixel holes on the Small World are not symmetric about the horizontal or vertical centerlines of the prop and vary by a few millimeters, this is most apparent on the center mount. To compensate for this variation the impacted pixel holes on the mount are elliptical and are placed at the average center point of the pixels. The mounts should be placed on the prop where the alignment averages out between the pixel and zip tie holes. We recommend not fully tightening the zip ties until the conduit is fully inserted to allow for small adjustment of the final fit.

General instructions for attaching mounts to coro props, including zip tie hole alignment, can be found by clicking this link.

Please follow and like us: